Notice ID: 3f537e2e244c48ee858f776b618c7c5cSolicitation
Bridgeport Float Valve Replacement
Archived on August 24, 2024. Original response deadline: . Full description on SAM.gov.
Overview
- Response deadline
- 12:00 PM UTC−06:00
- Posted
- July 26, 2024
- Notice type
- Solicitation
- Set-aside
- Small Business Set Aside - Total
- Agency
- Department of AgricultureFOREST SERVICE
Notice details
- Office
- USDA-FS, CSA INTERMOUNTAIN 8
- Place of performance
- Sparks, 89431
- Last updated
- Sep 25, 2026
Identifiers
- Solicitation number
- 1240LT24Q0064
- Notice ID
- 3f537e2e244c48ee858f776b618c7c5c
Description
Amendment 0001: This amendment serves to add the following information to Section C.3 SITE INFORMATION AND LIMITATIONS, located on page ten of the solicitation. This new paragraph will follow paragraph 5 and will be labeled as 6.: C.3 A. 6. The access road is a high clearance road accessible by ATV or UTV. The road is often saturated from the overflow from the water tank. All ruts caused or exacerbated by vehicular access shall be repaired and drainage shall be directed off the road. Hand shoveling ruts and creating waterbars would be acceptable. All other information, terms and conditions remain the same. The offer due date and time will remain the same. --------------------------------------------------------------------------------------------------------------------- SCOPE OF CONTRACT This project includes replacement of two existing float valves in the water storage tank for the Bridgeport Forest Service compound. This also includes calibration and the electrical work needed to operate the well successfully on a summer system and winter system. Disinfecting the tank will also be included in this project. The existing water tank is a 10,000 gallon stainless steel tank with 2 manholes. There are 2 float valves in a single valve box between the manholes. One valve controls a higher water level during the summer when more people live at the compound. And the other controls a lower water level in winter so the lower use does not result in stagnant water in the tank. The existing float valves have become disconnected and/ or twisted. A new radio communication system was installed in 2023 relaying water level signals to the well controls mounted on a house at the compound. Currently, the float valves do not operate correctly, and the well must be manually turned on and off to fill the water tank. It has been verified that the new radio controls do send a signal to the well but the signal from the floats to the radio controls is not there. This project is to install two float controls (summer/ winter) one in the manhole without the ladder and one in the existing valve box penetration. This layout could be changed with a proposal that would eliminate the chance the two floats would become tangled. The new float valves need to be wired so that they communicate with the new radio controls and successfully control the operation of the well. The old float valves will be removed and the entry into the water tank shall remain water and airtight. The design of this installation would be proposed by the contractor and approved by the CO. The water tank shall be cleaned, scrubbed, and disinfected after work is completed.
Award Overview
No prior contract identified
No prior award matched this notice's agency, NAICS, place of performance and PSC within 18 months. It may be a new requirement.
Contacts
Contracting Officer
Primary Contact
Tony Taylor - Contract Specialist
Secondary Contact
Anita Lusty
Documents
No documents available.
Lifecycle
Solicitation:
1240LT24Q0064- Solicitation
Award typically follows within 30–90 days after the response deadline. (estimate)
- 2×SolicitationCurrentJul 3, 2024
Bridgeport Float Valve Replacement
Similar Opportunities
Title | Match | Phase | Deadline |
|---|---|---|---|
Additional Details
Solicitation Number
1240LT24Q0064
Archive Date
Aug 24, 2024
Office Address
Ogden, UT, 844012310