GovChime
Notice ID: 33e777d7e1e46ab2bf56ae67cf3d46c4Solicitation

Install HSPD-12 Lenel ePACS

Archived on December 5, 2018. Original response deadline: . Full description on SAM.gov.

Overview

Response deadline
12:00 PM UTC−06:00
Posted
October 30, 2018
Notice type
Solicitation
NAICS
238210: Electrical Contractors and Other Wiring Installation Contractors
Agency
General Services AdministrationPUBLIC BUILDINGS SERVICE

Notice details

Office
PBS R8 ACQUISITION MANAGEMENT DIVISION
Place of performance
200 4th St SW, Huron, SD, 57350
PSC
Z: MAINT, REPAIR, ALTER REAL PROPERTY
Last updated
Dec 4, 2025

Identifiers

Solicitation number
47PJ0019R0003
Notice ID
33e777d7e1e46ab2bf56ae67cf3d46c4

Description

Work includes, but is not limited to: contractor shall provide labor, materials, equipment and supervision to perform the installation of a Lenel electronic physical access control system (ePACS) in the USDA office area, including (2) new mortise locks, (2) new Aiphone systems and all necessary wiring and equipment to have a complete system. All work will be performed at the Federal Building, Huron, South Dakota. Security clearances will be required for all workers. Work to be completed within 30 calendar days after award. Estimated cost range is between $25,000 and $100,000. The solicitation will be issued on October 30, 2018, with offers due on November 20, 2018. Anticipated award date is December 15, 2018. Information regarding a site visit will be announced in the solicitation. A site visit is recommended. This procurement is being set-aside for small businesses only. To be eligible for award, contractors must be registered and active with the System for Award Management (SAM) at https://www.sam.gov. All responsible sources submitting an offer will be considered. All those in receipt of the Government Documents are expected to safeguard the Sensitive but Unclassified information of this project in accordance with the "Document Security for Sensitive But Unclassified Building Information," GSA Order, PBS P 3490.2, dated September 2, 2014, which PROHIBITS the COPYING, DISSEMINATION, OR DISTRIBUTION OF THESE DRAWINGS, PLANS, OR SPECIFICATIONS TO UNAUTHORIZED USERS.

Full description on SAM.gov

Award Overview

No prior contract identified

No prior award matched this notice's agency, NAICS, place of performance and PSC within 18 months. It may be a new requirement.

Contacts

Documents

No documents available.

Lifecycle

Solicitation:47PJ0019R0003
  1. Pre-Solicitation
  2. Solicitation

Award typically follows within 30–90 days after the response deadline. (estimate)

  1. Pre-SolicitationOct 16, 2018

    Install HSPD-12 Lenel ePACS

    Notice 866248f32e250f120234e81d0a562b97 on SAM.gov

  2. SolicitationCurrentOct 30, 2018

    Install HSPD-12 Lenel ePACS

    Notice 33e777d7e1e46ab2bf56ae67cf3d46c4 on SAM.gov

Similar Opportunities

Title
Match
Phase
Deadline
The following are the firms shortlisted for Design Build services for the Carl B. Stokes U.S. Courthouse Fire Alarm Replacement Project in Cleveland, Ohio: Dawn Inc., 2861 Sferra Ave. NW, Warren, OH. 44483 Higley Construction, 3636 Euclid Ave., Cleveland, OH 44115 R.J. Runge Company, Inc., 3539 NE Catawba Rd., Port Clinton, OH 43452
-Special NoticeOpen
The GSA intends to award a Design-Build (DB) contract for the Carl B. Stokes U.S. Courthouse Fire Alarm Replacement project in Cleveland, Ohio. The solicitation will use two-phase design-build selection procedures pursuant to Federal Acquisition Regulation FAR 36.101-2 (GSA Class Deviation RFO-2025-36). The project includes the modernization of the primary life safety infrastructure to bring the building’s fire alarm and life safety systems up to current code while ensuring minimal disruption to daily federal operations. The building is a 23-story high-rise that encompasses approximately 767,000 gross square feet, including three lower levels and an integrated parking garage. The purpose of Phase I (the request for qualifications) is to select the most highly qualified Offerors to participate in Phase II (the request for proposals). At the conclusion of Phase I, GSA will invite the Short-Listed Offerors to submit Phase II proposals. Phase II proposals will require submission of technical and price proposals, which are evaluated separately in accordance with FAR Part 15. Potential Offerors are hereby placed on notice that GSA will publicly announce the names of the Phase I "short-list" on SAM.gov. A maximum of 3 Offerors will be selected to proceed to Phase II. At the conclusion of Phase II, GSA intends to award a contract to a single Offeror for all design and construction services. A $22,390.00 stipend will be distributed to the maximum of 2 unsuccessful short-listed offerors in Phase 2 that satisfy the terms of the Request for Proposal. This contract will be a full and open procurement, available to both large and small business firms. As part of the Phase II proposal, large business Offerors will be required to submit an acceptable small business subcontracting plan in accordance with FAR Part 19.7. A virtual pre-proposal meeting will be held on July 28, 2026, at 1:30 PM Central Time. Prospective attendees must RSVP to the Contracting Officer. Proposals are due no later than 4:00 PM CST, on August 21, 2026.
-Solicitation08/21/2026
-Market ResearchOpen
THIS IS A SOURCES SOUGHT NOTICE ONLY. THIS IS NOT A REQUEST FOR PROPOSAL OR INVITATION FOR BID. THERE WILL NOT BE A SOLICITATION, SPECIFICATIONS OR DRAWINGS AVAILABLE AT THIS TIME. The Naval Facilities Engineering Command, Mid-Atlantic is seeking eligible Small Businesses, HUBZone Small Businesses, Small Disadvantaged Businesses, Veteran-Owned Small Businesses, Service-Disabled Veteran-Owned Small Businesses, and Women-Owned Small Businesses capable of performing design-bid-build (DBB) construction services for project RM 7-01, Building 1029, at the Naval Foundry and Propeller Center, NAVSUPPACT Mechanicsburg, Pennsylvania (DET Philadelphia Navy Yard (PNY) Annex, Philadelphia, PA. The purpose of this project is to repair the existing electrical system in Building 1029 at the Naval Foundry and Propeller Center (NFPC), to provide a safe, environmentally controlled work area. Building 1029 is a 90,180 SF high bay industrial facility that was constructed in 1979. It is the inside machine shop for the Naval Foundry and Propeller Center and is responsible for the milling of all sizes of propellers for surface ships and submarines. Building 1029 equipment includes propeller profilers, PROMS (Propeller Robotic Optical Milling System), and various others milling machines, lathes, saws and grinders in support of the propeller manufacturing operations. These large profilers can mill propellers up to 24 feet in diameter and require a controlled environment to maintain milling tolerances. This project will repair the existing HVAC system and the installation of Air Conditioning in the High Bay of Building 1029. These repairs, replacements and equipment additions will improve the workplace environment inside the machine shop of Building 1029 at the NFPC with improved heating and ventilation to support ship and submarine propeller manufacturing and shall meet the operational requirements of manufacturing propellers within the specified temperature range to maintain its’ critical tolerance level for the future profilers to be located in the central bays of Building 1029. This Project will also replace the low voltage 480V aluminum cables with copper wiring between the substation and various power panels. In addition, all aluminum conductors from distribution panel boards to subpanels and associated transformers will be removed and replaced with copper conductors. New circuits will also be provided for the new equipment, and smoke detectors, with required fire alarm system interfacing in compliance with National Fire Protection Association (NFPA) requirements. Lastly, this project scope will also include the removal of abandoned steam lines and asbestos-containing and other hazardous materials. The work on this project must be performed in such a manner to prevent the equipment and operations housed within Building 1029 to not be visible when the replacement work is performed. The Contractor must coordinate with the Naval Foundry and Propeller Center to establish a construction phasing and sequence of construction which will meet the user requirements for continued operation and result in the least amount of disruption to the propeller shop operations and in a manner which would allow the Contractor to complete the work to achieve these requirements. Due to the layout of the equipment within the building and continued operation of the existing cranes within the building, construction of scaffolding or work platforms within the building is not feasible. The building must remain operational during all work of this project due to the nature of the propeller shop activities, work schedule which must be maintained and 24/7 shift work hours. Equipment will be allowed to be taken off-line for scheduled time frames as the work schedule/flow allows providing areas to allow overhead work to be performed. This will result in work phasing requirements. A work phasing sequence plan shall be established in coordination with the user. The Contractor will be required to follow this sequence of work indicated. The user, through the Contracting Officer Representative (COR), will be allowed to alter the sequence and direct the Contractor to work in a different area, based on scheduled equipment use. All use of Contractor supplied and utilized cranes, lifts, and booms must be coordinated with the COR, NAVFAC MIDLANT, and the Navy Crane center thru the COR. Any use of cranes, lifts or booms within the building must be transparent to the operation of the building user operations. The Contractor will not be allowed to utilize the existing bridge cranes within the building. Building 1029 is a restricted entry building located at the Navy Yard, Philadelphia, PA. Contractors must employ United States citizens and the Contractor must obtain CONFIDENTIAL Clearance for all personnel working in Building 1029. The company must first obtain clearance, and then all employees must obtain CONFIDENTIAL Clearance. Contract Clause FAR 52.204-2, Security Requirements and Alternate II, FAC 5252.236-9301, Special Working Conditions and Entry to Work Area, applies. Contractor personnel and other personnel associated with the Contractor in performing the work specified under this contract work must comply with the security requirements and classification of this procurement as indicated in Form DD 254. The appropriate Northern American Industry Classification System (NAICS) code for this procurement is 238210 – Electrical Contractors and Other Wiring Installation Contractors, and the Small Business Size Standard is $15,000,000. In accordance with FAR 36.204, the magnitude of construction for this project is between $5,000,000 and $10,000,000. The contract will include FAR clause 52.219-14 Limitations on Subcontracting, which states that “The concern will perform at least 15 percent of the cost of the contract, not including the cost of materials, with its own employees.� This office anticipates award of a contract for these services by May 2017. It is requested that interested small businesses submit to the Contracting Officer a capabilities package, to include the Sources Sought Contractor Information Form, Sources Sought Project Information Form and Sources Sought Project Matrix, provided as attachments to this notice. The Sources Sought Project Information Form and Sources Sought Project Matrix shall be used to document a minimum of three (3) and up to a maximum of five (5) relevant construction projects completed in the past five (5) years that best demonstrate experience on projects that are similar in size, scope and complexity to the project described herein. A relevant project is further defined as: Size: Final construction cost greater than five million dollars ($5M). Scope: Construction or renovation of an industrial manufacturing facility or technical research center with major mechanical and electrical system upgrades, including HVAC and lighting. Complexity: Phased building construction activities where the facility remaining occupied during construction. Ensure that the project description clearly identifies whether the project is new construction or renovation, provides the square footage and final construction cost, and addresses how the project meets the scope/complexity requirements. Please note that if you are responding as an 8(a) Mentor-Protégé, you must indicate the percentage of work to be performed by the protégé. A copy of the SBA letter stating that your 8(a) Mentor-Protégé agreement has been approved would be required with your proposal, if requested. This notice is a market research tool being used to determine the availability and adequacy of potential small business sources prior to determining the method of acquisition and ultimate issuance of a solicitation. Upon review of industry response to this sources sought notice, the Government will determine whether set-aside procurement in lieu of full and open competition is in the Government’s best interest. Large business submittals will not be considered. The Government is not obligated to and will not pay for any information received from potential sources as a result of this notice. The information provided in this notice is subject to change and in no way binds the Government to solicit for or award a contract. The Government will not provide debriefs on the results of this research, but feedback regarding the decision to set aside or not set aside the procurement will be accomplished via pre-solicitation synopsis or solicitation for these services, as applicable. All information submitted will be held in a confidential manner and will only be used for the purpose intended. Points of contact listed may be contacted for the purpose of verifying performance. RESPONSES ARE DUE NLT 06 January 2017 at 2:00 PM (EST). LATE SUBMISSIONS WILL NOT BE ACCEPTED. The package shall be sent via electronic mail to Brett Garnett at brett.garnett@navy.mil Attachments are limited to a total of 5MB.
-Market ResearchOpen
The 28th Contracting Squadron, Ellsworth AFB, South Dakota, has issued this Solicitation, FA469026Q0027, to compete and award a single award Firm Fixed Price (FFP) contract using FAR Part 12-Acquisition of Commercial Items, for the maintenance of the Infrared Radiant Heating Systems on Ellsworth AFB. Further details of the requirement are included in the attached Performance Work Statement.This award will have one base year plus four option years. The projected Period of Performance is 8 December 2026 - 7 December 2031. This will be a 100% Small Business set aside solicited under North American Industry Classification System (NAICS) code 238220 with a size standard of $19M. To be eligible to compete for Small Business set-aside awards, vendors must be certified in accordance with current Small Business Administration (SBA) regulations.All interested and responsible entities are invited to submit a quote that will be considered by the 28th Contracting Office at Ellsworth AFB, South Dakota. The award will be based on the criteria established in the solicitation.Small Business contractors submitting a quote must have and list within the quote the vendors assigned Cage and be registered and ACTIVE in the System of Award Management (SAM) at www.sam.gov to receive an award for this procurement.
-Combined Synopsis10/28/2026

Additional Details

Solicitation Number

47PJ0019R0003

Archive Date

Dec 5, 2018

Office Address

LAKEWOOD, CO, 80225