GovChime
Notice ID: 80517f6968e947f79ed927f3c7c802c4Combined Synopsis/Solicitation

COMBINED SYNOPSIS/SOLICITATION Purchase Scrap Railroad Wheels with Shafts

Archived on December 5, 2019. Original response deadline: . Full description on SAM.gov.

Overview

Response deadline
3:00 PM UTC−08:00
Posted
November 27, 2019
Notice type
Combined Synopsis/Solicitation
Set-aside
Small Business Set Aside - Total
NAICS
331511: Iron Foundries
Agency
Department of CommerceNATIONAL OCEANIC AND ATMOSPHERIC ADMINISTRATION

Notice details

Office
DEPT OF COMMERCE NOAA
Place of performance
Seattle, 98115
Last updated
Sep 25, 2026

Identifiers

Solicitation number
PMEL-20-00124
Notice ID
80517f6968e947f79ed927f3c7c802c4

Description

COMBINED SYNOPSIS/SOLICITATION Purchase Scrap Railroad Wheels with Shafts (I) This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice and in accordance with the simplified acquisition procedures authorized in FAR Part 13. This announcement constitutes the only synopsis/solicitation; proposals are being requested and a written solicitation will not be issued. (II) This solicitation is issued as a request for quotation (RFQ). Submit written quotes on RFQ Number PMEL-20-00124 (III) The solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular 2019-06. (IV) This solicitation is being issued with a total small business Set-aside. The associated NAICS code is 331511 and the PSC code is PSC 9670. (V) This combined solicitation/synopsis is for purchase of the following commercial items: Quantity of 24 Type B Railroad wheels TYPE B--Scrap railroad wheel with axel pressed out. Minimum hole diameter eight and one fourth (8-1/4") inches, with a weight of 840 pounds, +- 30 pounds. Quantity of 4 scrap railroad wheels with cut shafts as specified below. Scrap railroad wheel with shaft flame cut or better 42 inches from inside of wheel. Cut should be level+/- one-half (1/2") inch. Approximate weight is 1200 - 1400 pounds. The maximum shaft diameter at cut not to exceed seven and one-half (7-1/2") inches. Axel must be flush cut on bottom to allow wheel to sit flat on a flat surface. Wheel axel shaft shall contain a drilled hole of one and nine-sixteenths (1-9/16 ") inches diameter through the center of the shaft with the hole centered+/- one-quarter (1/4") inch, two and one-half (2-1/2 ") inches below the cut edge of the axel, and parallel to the base to the wheel. The hole shall allow for insertion of a fourteen (14") inch long, one and one-half (1-1/2") inch diameter steel rod completely through the shaft. The knuckle on the shaft shall not exceed an outside diameter of 8". (VI) Description of requirements is as follows: Railroad wheels and shafts as describe above. (VII) Date(s) and place(s) of delivery and acceptance 12/27/2019 Shipping will be FOB Destination. (VIII) Questions must be emailed to the attention of Ben Carlson. The email address is Ben.Carlson@noaa.gov , 206-526-4321. THE FOLLOWING PROVISIONS AND ATTACHED CLAUSES APPLY TO THIS ACQUISITION FAR 52.212-1, Instructions to Offerors -- Commercial Items applies to this acquisition. FAR 52.212-3, Offeror Representations and Certifications – Commercial Items CAR 1352.201-70 Contracting Officer’s Authority CAR 1352.209-73 Compliance with the Laws CAR 1352.209-74 Organizational Conflict of Interest CAR 1352.233-70 Agency Protests CAR 1352.233-71 GAO and Court of Federal Claims Protests CAR 1352.237-71 Security Processing Requirements - Low Risk Contracts COMBINED SYNOPSIS/SOLICITATION Purchase Scrap Railroad Wheels with Shafts (I) This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR Subpart 12.6, as supplemented with additional information included in this notice and in accordance with the simplified acquisition procedures authorized in FAR Part 13. This announcement constitutes the only synopsis/solicitation; proposals are being requested and a written solicitation will not be issued. (II) This solicitation is issued as a request for quotation (RFQ). Submit written quotes on RFQ Number PMEL-20-00124 (III) The solicitation document and incorporated provisions and clauses are those in effect through Federal Acquisition Circular 2019-06. (IV) This solicitation is being issued with a total small business Set-aside. The associated NAICS code is 331511 and the PSC code is PSC 9670. (V) This combined solicitation/synopsis is for purchase of the following commercial items: Quantity of 24 Type B Railroad wheels TYPE B--Scrap railroad wheel with axel pressed out. Minimum hole diameter eight and one fourth (8-1/4") inches, with a weight of 840 pounds, +- 30 pounds. Quantity of 4 scrap railroad wheels with cut shafts as specified below. Scrap railroad wheel with shaft flame cut or better 42 inches from inside of wheel. Cut should be level+/- one-half (1/2") inch. Approximate weight is 1200 - 1400 pounds. The maximum shaft diameter at cut not to exceed seven and one-half (7-1/2") inches. Axel must be flush cut on bottom to allow wheel to sit flat on a flat surface. Wheel axel shaft shall contain a drilled hole of one and nine-sixteenths (1-9/16 ") inches diameter through the center of the shaft with the hole centered+/- one-quarter (1/4") inch, two and one-half (2-1/2 ") inches below the cut edge of the axel, and parallel to the base to the wheel. The hole shall allow for insertion of a fourteen (14") inch long, one and one-half (1-1/2") inch diameter steel rod completely through the shaft. The knuckle on the shaft shall not exceed an outside diameter of 8". (VI) Description of requirements is as follows: Railroad wheels and shafts as describe above. (VII) Date(s) and place(s) of delivery and acceptance 12/27/2019 Shipping will be FOB Destination. (VIII) Questions must be emailed to the attention of Ben Carlson. The email address is Ben.Carlson@noaa.gov , 206-526-4321. THE FOLLOWING PROVISIONS AND ATTACHED CLAUSES APPLY TO THIS ACQUISITION FAR 52.212-1, Instructions to Offerors -- Commercial Items applies to this acquisition. FAR 52.212-3, Offeror Representations and Certifications – Commercial Items CAR 1352.201-70 Contracting Officer’s Authority CAR 1352.209-73 Compliance with the Laws CAR 1352.209-74 Organizational Conflict of Interest CAR 1352.233-70 Agency Protests CAR 1352.233-71 GAO and Court of Federal Claims Protests CAR 1352.237-71 Security Processing Requirements - Low Risk Contracts

Full description on SAM.gov

Award Overview

No prior contract identified

No prior award matched this notice's agency, NAICS, place of performance and PSC within 18 months. It may be a new requirement.

Contacts

Contracting Officer

Primary Contact

Ben Carlson
Fax: 2065266815

Documents

No documents available.

Lifecycle

Solicitation:PMEL-20-00124
  1. Combined Synopsis
  1. 2×
    Combined SynopsisCurrentNov 13, 2019

    COMBINED SYNOPSIS/SOLICITATION Purchase Scrap Railroad Wheels with Shafts

    Notice 80517f6968e947f79ed927f3c7c802c4 on SAM.gov

Similar Opportunities

Title
Match
Phase
Deadline
SALE OF SCRAP METAL TERMS AND CONDITIONS Red River Army Depot (RRAD) expects to generate, over the course of a year, approximately 2.5 million lbs. of railroad steel. The weight of the scrap is an estimate. Agreement to purchase these items shall be documented on SF 114A-C (see attached) The above scrap commodities will be sold to Buyer based on the Buyer’s index percentage price for the corresponding commodities in the AMM Steel scrap No. 1 heavy melt Chicago and the Buyer’s ability to accept the mentioned scrap material. The Government requires the Buyer to provide a courtesy copy of the index each month. Please send the copy to Cody Gardner (cody.d.gardner.civ@army.mil) and Zachary Gilmore (zachary.t.gilmore.civ@army.mil). This is an all or none sale. The buyer shall provide all equipment and labor to load and transport material. The buyer will be required to follow the AWCF Scrap Pickup Process listed on the next page of this contract. There shall not be any additional charges for performing the “pickup process” mentioned above. An invoice will be processed, showing the tare weight and loaded weight of roll off, and sent to the Buyer via Pay.gov. Payment in full is required, prior to scrap removal. Once payment is received the Buyer will be notified. For payment of commodities an invoice will be processed. For material loaded into rolloff(s) the tare and loaded weight will be sent to the Buyer, via Pay.Gov. For invoices not paid within twenty business hours (Monday-Thursday) a daily surcharge of $100 will be implemented. Payment in full is required prior to release of commodities from RRAD. Once payment is received, the Buyer and RRAD will be notified. The buyer shall send the below information to Amanda Martin (amanda.e.martin23.civ@army.mil) or Kathy Ellis (kathy.l.ellis10.civ@army.mil): Company Name Address City, State, Zip Code Phone number Primary and alternate Email Address Payment is to be made through Pay.gov at the following address: https://www.pay.gov/public/home Instructions on how to create a Pay.gov account can be found on the website. DANGEROUS PROPERTY: Buyers are cautioned that articles or substances of dangerous nature may remain in the property regardless of the care exercised to remove same. The government assumes no liability for damages to property of the Buyer or for personal injury, disability, or death of the Buyer, its employees, or to any other person arising from or affiliated with the purchase, use or dispositions of this material. The Buyer shall hold the government harmless from all such demands, suit, actions, or claims arising from or otherwise relating to the purchase of this material. Hazardous Material Spill: The buyer shall be responsible for any spills pursuant to this agreement while on Red River Army Depot and shall immediately report any spills to the RRAD dispatch by calling 903-334-3333. The buyer agrees to expeditiously cleanup all spills or leaks in a manner that complies with all federal, state, and local environmental laws and regulations. The cleanup shall be at no cost to the government and the buyer agrees to hold the government harmless and indemnify the government for any costs incurred because of, or incidental to, any handling, removal, transportation, storage, treatment, or disposal of materials performed by the buyer or its subcontractors. In the case of imminent health and safety dangers, the government reserves the right to take immediate action to contain a spill or to otherwise minimize the threat to health and safety. The buyer shall reimburse the government for the costs incurred upon submission of a bill for its actual cost in taking such action. In the event of a spill, the buyer may request support from the installation on a cost reimbursable basis. The buyer shall have on hand and use as needed appropriate and sufficient supply of spill prevention and containment cleanup materials which are compatible with the substances they are intended to cleanup so as not to create incompatibility and hazards during spill cleanup effort. Areas of Work: Buyer shall coordinate and schedule ALL work concerning this project, (storage area requirements, work area requirements, work area, utilities, scheduling activities, traffic control and daily clean-up, etc) with the RRAD AWCF Recycling Program Manager, prior to any work activity at or around the designated site. Buyer shall keep the work area and the immediate surrounding area, in a clean, uncluttered manner to maintain a safe working environment for all personnel in and around the site. AWCF Scrap Pickup Process Takes approximately 20 mins Buyer does this To do what? Brings empty trailer Weighs truck w/empty trailer To determine tare weight Weighs truck with full trailer Use scale weight of full roll off for new invoice Leaves with full paid for material Or Brings empty roll off Weighs truck w/empty roll off Unloads Empty Weighs Truck w/o roll off To determine empty roll off weight Loads full roll off Weighs truck with full roll off Use scale weight of full roll off for new invoice Unloads full roll off Loads a paid for roll off on truck Leaves with full paid for roll off
46%
Solicitation12/01/2026
Purchase of Scrap Railroad Wheels
60%
AwardedArchived
Open
48%
AwardedOpen
47%
AwardedOpen
41%
AwardedOpen

Additional Details

Solicitation Number

PMEL-20-00124

Archive Date

Dec 5, 2019

Office Address

KANSAS CITY, MO, 64106