GovChime
Notice ID: d9ffb229ffba3dfe4fb2353dd66d735fSolicitation

Replacement of Air Handling Unit Dampers at the SSA Facility in Queens, NY

Archived on April 18, 2011. Full description on SAM.gov.

Overview

Posted
August 18, 2008
Notice type
Solicitation
Set-aside
Small Business Set Aside - Total
NAICS
238220: Plumbing, Heating, and Air-Conditioning Contractors
Agency
Social Security Administration

Notice details

Office
SSA OFC OF ACQUISITION GRANTS
Place of performance
155-10 Jamaica Avenue, JAMAICA, 11432
PSC
41: REFRIG, AIR CONDIT/CIRCULAT EQPT
Last updated
Sep 25, 2026

Identifiers

Solicitation number
SSA-RFQ-02-08-1002
Notice ID
d9ffb229ffba3dfe4fb2353dd66d735f

Description

The Social Security Administration, Region II, seeks a contractor to replace damaged Air Handling Unit system dampers (fresh air supply, minimum, return and spill) at the following facility: Joseph P. Addabbo Federal Building (Northeast Program Service Center), 155-10 Jamaica Ave., Jamaica, NY 11432. In each location identified by SSA, the contractor shall remove existing dampers on Air Handling Units. Included are spill air dampers, return fan dampers, minimum fresh air dampers, fresh air dampers and insuring that the manufacture and installation of the dampers meet or exceed the standards set forth by SMACNA (Sheet Metal and Air Conditioning Contractors’ National Association). Replacement dampers shall be manufactured of anodized aluminum. Replacement dampers shall be of opposed blade design (rather than parallel). Linkages must be manufactured of a non-corrosive material. Linkages must be concealed within the frame. Linkages must be made of five-eighth inch x one eighth inch aluminum bar. Frames must be made of extruded aluminum, minimum thickness of .050”. Blades must be manufactured of extruded aluminum, minimum thickness of .050 inches. Blade seals on fresh air and minimum air dampers must be made with compression jamb seals of stainless steel. Control shaft is to be factory installed, one-half inch x six inches with outboard support bearings. Each section of the damper is to be supplied with a bronze iolite bearing. The Request for Quotation containing the full Statement of Work and all provisions is expected to be issued on approximately August 18, 2008 and may be downloaded at http://www.fedbizopps.gov. Prospective quoters will be afforded a site visit, the date for which will be contained in the solicitation. This is a total small business set aside, conducted under FAR Part 12, Acquisition of Commercial Items. The NAICS code is 238220 with a size standard of $13 million.

Full description on SAM.gov

Award Overview

No prior contract identified

No prior award matched this notice's agency, NAICS, place of performance and PSC within 18 months. It may be a new requirement.

Contacts

Contracting Officer

Primary Contact

Andrew Argiro
Fax: 212-264-2964

Documents

No documents available.

Lifecycle

Solicitation:SSA-RFQ-02-08-1002
  1. Pre-Solicitation
  2. Solicitation

Award typically follows within 30–90 days after the response deadline. (estimate)

  1. Pre-SolicitationAug 16, 2008

    Replacement of Air Handling Unit Dampers at the SSA Facility in Queens, NY

    Notice 59aa00823bc10bef9bc3edc048605b67 on SAM.gov

  2. SolicitationCurrentAug 18, 2008

    Replacement of Air Handling Unit Dampers at the SSA Facility in Queens, NY

    Notice d9ffb229ffba3dfe4fb2353dd66d735f on SAM.gov

Similar Opportunities

Title
Match
Phase
Deadline

Additional Details

Solicitation Number

SSA-RFQ-02-08-1002

Archive Date

Apr 18, 2011

Office Address

BALTIMORE, MD, 21235